Operation in b1, b2 settings – Invotel SX8500 User Manual

Page 4

Operation in B1, B2 settings:

To activate: press then

To deactivate just re-select that line and press

Voice Deactivation: if the call has been on Hold at least a few seconds, it can also be deactivated by
just speaking over the Audio for example say : “Hi I am Back” .

If for some reason you are not able to voice -deactivate, try speaking a little louder and more direct
into the microphone, if that does not work hang up and set the switch to B2. Remember you can
always use the Flash button to deactivate the audio as well.

Want to use just one button ? Press to activate MOH and when ready to go back to
caller just speak over the audio!. Or press Flash again. Note: this does not hold the line so the other
party may still hear you, set the volume louder to mask it.

In B1 or B2 or C3 settings the Flash button is used in order to activate the audio so if you have any
service such as: Call waiting , 3 way calling, Centrex Call Transfer

Use

to access an out side line or to answer a call waiting call etc.

Example 1 ( B1 or B2 settings ) to take a call waiting call press

Example 2 ( B1, B2 ) to make a 3 way or conference call press

you will get a dial-tone

now dial the desired phone number & press

to join the two calls together.

NOTE: If you have “Call Waiting” service, only one call may be placed on Music-On-Hold, the other
call is

held in the phone company central office in silence not in your office.

Hang up and set left switch to middle and right switch to left

FLASH

HOLD

FLASH

FLASH FLASH

FLASH

Tip: If you have audio flicker problem , Reduce the Volume

A B C 1 2 3