Invotel SX9600 - Manual

Warranty
This product is warranted against defects for a period of Three (3) years from the date of
original invoice. We will repair/replace the product with no charge for parts or labor within this
time. To obtain warranty service the product needs to be returned freight prepaid by the
customer with a copy of original invoice. This warranty does not apply if in the sole opinion of
Innovative Telecommunication Technology, the product has been tampered with or damaged by
lightning or any other acts of nature, misuse, neglect or unauthorized service.
EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT, THERE ARE NO OTHER
WARRANTIES, EXPRESSED OR OTHERWISE,INCLUDING, BUT NOT LIMITED TO ANY
IMPLIED WARRANTIES OR MERCHANTIBILITES OR FITNESS FOR A SPECIAL PURPOSE.
IN NO EVENT SHALL INNOVATIVE TELECOMMUNICATION TECHNOLOGY (INVOTEL) BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS , INDIRECT, SPECIAL, CONSEQUENTIAL
OR OTHERWISE ARRISING FROM ANY BREACH OF THIS WARRANTY OR OTHERWISE.
®
1112 Montana Ave Suite 250 Santa Monica, CA 90403 USA
Toll-Free: 800-747-0708 Tel: 310-899-0078 Fax: 310-899-0227 http://www.invotel.com
User Manual
Invotel
DS 9600
Rev 01
Digital Audio System Recorder
• Plug the included AC adapter. (110V AC to 9-12V)
• • • • Connect your PC speaker out jack to “Y” patch cable, then connect your
speakers(if any) to one port of “y” audio patch cord and the DS9600
“Audio IN” jack to the other port of “y” patch cable using the provided 6
feet audio cord.
•
Insert the MX9008 or MX9017 Flash Card into the slot as shown (be sure to
insert the card all the way down into the blue connector)
•
LED Green light turns ON to indicate device is ready to record
• Unplug the power connector wait 30 seconds then plug it back
in. make sure the connector is plugged in securely. Be sure to
observe the LED GREEN light turns ON.
• Be sure MX9008 or MX9017 card is inserted all the way down
into it’s slot securely. The cut out on that card must be toward the
right see the picture in page 1
• Check audio cord; try re-inserting it again, adjust the volume on
your PC, make sure it is not muted, make sure you can hear the
audio from your speakers.
Audio quality is poor • Verify that the audio cord is plugged in securely, Make sure the
audio volume on your PC is not too loud, for best results keep
the volume levels to about 75% - this device works fine at any
audio level from 25% to 100%
Cannot start the recording • Make sure you can hear the audio from your speakers . this
device needs to hear the audio to start recording. Try the
Manual recording- see page 3
Recorder not working or
stopped working
Problems Possible Cause / Solution
P4
110 V
DS9600
DIGITAL
FLASH MEMORY
Technology
AC adapter AUDIO IN
PC
Speaker
OUT
PC
speakers
“Y” Patch cable
3.5mm to 3.5mm audio cord
MX9008 Card
REC
IN