Invotel SX9500P - Manual

Warranty
This product is warranted against defects for a period of Three (3) years from the date of
original invoice. We will repair/replace the product with no charge for parts or labor within this
time. To obtain warranty service the product needs to be returned freight prepaid by the
customer with a copy of original invoice. This warranty does not apply if in the sole opinion of
Innovative Telecommunication Technology, the product has been tampered with or damaged by
lightning or any other acts of nature, misuse, neglect or unauthorized service.
EXCEPT AS SPECIFICALLY PROVIDED IN THIS AGREEMENT, THERE ARE NO OTHER
WARRANTIES, EXPRESSED OR OTHERWISE,INCLUDING, BUT NOT LIMITED TO ANY
IMPLIED WARRANTIES OR MERCHANTIBILITES OR FITNESS FOR A SPECIAL PURPOSE.
IN NO EVENT SHALL INNOVATIVE TELECOMMUNICATION TECHNOLOGY (INVOTEL) BE
LIABLE FOR LOSS OF PROFITS OR BENEFITS , INDIRECT, SPECIAL, CONSEQUENTIAL
OR OTHERWISE ARRISING FROM ANY BREACH OF THIS WARRANTY OR OTHERWISE.
®
1112 Montana Ave Suite 250 Santa Monica, CA 90403 USA
Tel: 310-899-0078 Fax: 310-857-6401 http://www.invotel.com
User Manual
Invotel
SX9500P
Rev 01
Digital Audio System Player/Recorder
• Adjust playback volume level if needed
•
Plug the included AC adapter. (110V AC to 6-12VDC)
•
LED Green light turns ON dancing with RED to indicate device is playing
back.
• Unplug the power connector wait 30 seconds then plug it back
in. make sure the connector is plugged in securely. Be sure to
observe the LED GREEN light turns ON.
• Check RCA audio cord; try re-inserting it again,
• Make sure the recording cord is unplugged (the unit will not play if
recording cord is connected)
Audio quality is poor • Verify that the audio cord is plugged in securely, Make sure the
audio volume on your PC is not too loud, for best results keep
the volume levels to about 75% - this device works fine at any
audio level from 25% to 100%
Cannot start the recording
• Make sure you can hear the audio from your speakers . this
device needs to hear the audio to start recording. Adjust the
volume on your PC or CD player if you need. If CD player use
the Headphone jack not “line out”. Make sure the connecting
cord is plugged in. Make sure Green LED starts blinking to
indicate it is connected and ready to record.
Player not working or
stopped working
Problems Possible Cause / Solution
P4
110 V
DIGITAL
FLASH MEMORY
Technology
DC IN
TELEPHONE SYSTEM
MOH PORT or Music On
Hold Adapter
Red Green
Volume
Adjustment
Re-apply
power after
adjusting
MAX
Min