Yaskawa Modicon 800 Series Remote I/O Network for use on Microtrac LAN - Manual (Page 6)

Table 2. Modicon I/O Interface Card Setup
indicates if
off
card is loaded with software
LED1 green
card is (normal)
LEDs loaded with
on
card needs to be loaded with
software software
LED2 red power indicator
off no power to gateway
on power on gateway (normal)
Connector bnc connects to Modicon remote i/o network
the host computer
base port address 1 2 3 4 5 6
uses a block of
Switch S1 8 I/O address to 0x260 o o o o o o
control the operation (default) n n f f n n
of the card (download) f f
J6
enable power up enabled (default) 2-3
memory disabled 1-3
Jumpers base address J4 J5
the interface card uses 0x9000 2-3 2-3
J4, a block of 64K bytes of 0xA000 1-3 2-3
J5 memory in the host 0xC000 1-3 1-3
computer 0xD000 (default) 2-3 1-3
J1
method of grounding through R-C circuit cap (default)
bnc shield directly to ground direct
2 HARDWARE
5 Modicon I/O Interface Card
5/24/96
This card is connected to the Modicon 800 Series I/O network using a coaxial
cable connected to the BNC connectors on the front of the card. It is
connected to the network in the same way as the real drops. Refer to the
Modicon installation guide for information on appropriate types of cable.
CAUTION
The card does not contain a 75-ohm termination resistor, so an
external resistor is necessary at the card end of the cable. (Use
supplied bnc in-line terminator.)
Modicon I/O
Interface Card
RD 3004-20