Yaskawa Modicon 800 Series Remote I/O Network for use on Microtrac LAN - Manual (Page 4)

Table 1. MicroTrac Network Interface Card Setup
LEDs CR1
green MicroTrac LAN has connection with the card
red gateway software has made connection with the card
node 1 2 3 4 5 6 7 8
The MicroTrac 200 up up dn dn up dn dn dn
LAN node 201 up up dn dn up dn dn up
Switch SW1 number setting 202 up up dn dn up dn up dn
(default = 200) 203 up up dn dn up dn up up
204 up up dn dn up up dn dn
205 up up dn dn up up dn up
Connector bnc connects to MicroTrac LAN either directly or through Hub card
response reconfigure
The time-out time-out ET1 ET2
ET1, ARCnet (msec) (ms)
E3 ET2 time-out 74.7 840 (default) open open
option 283.4 1680 open short
561.8 1680 short open
1118.6 1680 short short
enrom used to enable an option boot ROM, open default
which would go in the empty socket disable
IRQ2 open
Jumpers used to select one of the IRQ3 short
E4 eight selectable PC interrupts IRQ4 open default
IRQ5 open
IRQ7 open
MSO user configuration of MSO short
MS1 memory map MS1 short
MS2 default address range MS2 open default
E1 MS3 RAM = E:0000 - D:07FF MS3 open
MS4 PROM = E:2000 - E:3FFF MS4 open
IOS0 user configuration of i/o IOS0 short
IOS1 map IOS1 open default
IOS2 default range 2E0 - 2EF IOS2 short
2 HARDWARE
3 MicroTrac Network Interface Card
5/24/96
M i c r o Tr a c
N e t w o r k
Interface Card
RD 3004-20