Yaskawa Modicon 800 Series Remote I/O Network for use on Microtrac LAN - Manual (Page 3)

2 HARDWARE
2 Setup
5/24/96
The gateway should be mounted so that the LEDs on the cards can be seen. There
should also be sufficient clearance so that the coaxial connection can be made to
the interface. The dimensions of the gateway enclosure are shown below.
Figure 2. Dimensions of Gateway Enclosure
S e t u p Each of the three cards installed in the back plane has jumpers and switches
that must be set before insertion into the back plane.
RD 3004-20