SMA SC 500CP XT Installation - Manual (Page 20)

10. Transport the inverter as close to the floor as possible.
11. Transport the inverter to the mounting location and set it down on a suitable surface.
12. Place the roof on the inverter.
13. Screw the grounding conductor to the inverter (torque: 14.2 Nm).
14. Slide the roof into the guide rails on the inverter and pull
forward.
15. Press the roof down.
16. Mount the ventilation grids (see Section 7.2.3, page 42).
4.4 Mounting of the Inverter
4.4.1 Mounting the Inverter on a Foundation
Requirements:
☐ The inverter must be off the Euro pallet.
☐ The inverter is at the mounting location.
☐ The mounting holes must be drilled in the foundation and appropriate screw anchors inserted (see
Section 4.2.3.1, page 16).
Additionally required material (not included in the scope of delivery):
☐ Six suitable screws to attach the inverter
Procedure:
• Attach the inverter to the mounting surface with the bolts.
4.4.2 Mounting the Inverter on a Base
Requirements:
☐ The inverter must be off the Euro pallet.
☐ The inverter is at the mounting location.
☐ The base must be prepared for installation (see Section 4.2.3.2, page 16).
Additionally required material (not included in the scope of delivery):
☐ Six suitable hammer nuts to attach the inverter
Procedure:
• Attach the inverter with the screws (from the scope of delivery of the base) and hammer nuts to the base.
4 Transport and Mounting SMA Solar Technology AG
Operating Manual SCCPXT-IA-E4-en-44 20