SMA Webconnect Systems in SUNNY PORTAL - Manual (Page 44)

7 System Settings SMA Solar Technology AG
44 SPortalWebcon-BA-en-13 User Manual
7.8 Entering the Feed-In Tariff
Requirement:
☐ You must have the user role Installer or Administrator (see Section 10.1 "User Roles and
User Rights in Sunny Portal", page 56).
Procedure:
1. Select Configuration > PV System Properties in the page and menu selection.
2. Select the tab Parameters.
3. Select [Edit].
☑ The menu for setting parameters opens.
4. In the area Reimbursement, enter the feed-in tariff per kWh in the field Reimbursement /
Currency. At the same time, select the desired currency in the accompanying drop-down list.
5. Select [Save].
7.9 Entering the Amount of CO
2
Avoided
The CO
2
factor indicates how much CO
2
is produced during the generation of one kilowatt hour.
The CO
2
factor can vary depending on the grid operator. To find out the CO
2
factor for one kilowatt
hour of electricity, contact your grid operator.
Sunny Portal uses the CO
2
factor value to calculate how much CO
2
has been saved by the power
generation of your system.
You can view the amount of CO
2
avoided on the following pages:
• PV system profile page
• Daily info report or Monthly info report (see Section 6.3 "Reports", page 32).
Requirement:
☐ You must have the user role Installer or Administrator (see Section 10.1 "User Roles and
User Rights in Sunny Portal", page 56).
Procedure:
1. Select Configuration > PV System Properties in the page and menu selection.
2. Select the tab Parameters.
3. Select [Edit].
☑ The menu for setting parameters opens.
4. In the appropriate field in the Factor area, enter the CO
2
factor or click the slide control and
hold the left mouse button pressed to set the CO
2
factor.
5. Select [Save].