HEIDENHAIN PWM 20 - Manual (Page 160)

August 2014 Pin layouts 161
4.3.97 Adapter 15/15-pin HTL/HTLs
* Switchover I
2
C-PWM20_AdapterHTL on/off via: PWM20.ioPorts.EN_SHIELD
The assignment of the female connector is set via the active PWM 20 input (X1) according to
the connected encoder.
1
9
2
10
3 5 4 6 8 7
11 12 13 14 15
8
15
7
14
6 4 5 3 1 2
13 12 11 10 9
Messgerät
Encoder
PWM 20
Adapter ID 1093210-01
Adapter ID 1093210-01
Signal (vom Messgerät vorgegeben)
Signal (prescribed by the encoder)
Stecker 15-pol. Buchse
15-pin connector (female)
Stecker 15-pol. Stift
15-pin connector (male)
PIN 1 HTL: +Ua1 PIN 1
PIN 2 0 V PIN 2
PIN 3 HTL: +Ua2 PIN 3
PIN 4 HTL: U
P
PIN 4
PIN 5 EnDat: +DATA PIN 5
PIN 6 Schirm * / shield PIN 6
PIN 7 HTL: -Ua0 PIN 7
PIN 8 EnDat: +CLOCK PIN 8
PIN 9 HTL: -Ua1 PIN 9
PIN 10 HTL: -Sensor PIN 10
PIN 11 HTL: -Ua2 PIN 11
PIN 12 HTL: +Sensor PIN 12
PIN 13 HTL: +UaS; EnDat: -DATA; I
2
C: DAT PIN 13
PIN 14 HTL: +Ua0 PIN 14
PIN 15 EnDat: -CLOCK; I 2 C: DAT PIN 15