Plan view, Projection in three planes, Test run and program run 17.1 graphics – HEIDENHAIN TNC 640 (34059x-05) ISO programming User Manual

Page 554

Test run and program run

17.1

Graphics

554

TNC 640 | User's ManualDIN/ISO Programming | 1/2015

Plan view

Select the plan view in the

Test Run operating mode:

Press the

FURTHER VIEW OPTIONS soft key

Press the plan-view soft key

Select the plan view in the

Program Run, Single Block and

Program Run, Full Sequence operating modes:

Press the

GRAPHICS soft key

Press the plan-view soft key

Projection in three planes

The simulation shows three sectional planes and a 3-D model,

Similar to a technical drawing.
Select projection in three planes in the

Test Run operating mode:

Press the

FURTHER VIEW OPTIONS soft key

Press the view-in-three-planes soft key

Select projection in three planes in the

Program Run, Single Block

and

Program Run, Full Sequence operating modes:

Press the

FURTHER VIEW OPTIONS soft key

Press the view-in-three-planes soft key

Move the sectional planes

Select the functions for shifting the sectional

plane. The TNC offers the following soft keys: