HEIDENHAIN TNC 640 (34059x-05) ISO programming User Manual

Page 504

Manual operation and setup

15.5 Datum management with the preset table

504

TNC 640 | User's ManualDIN/ISO Programming | 1/2015

Editing the preset table

Soft key

Editing function in table mode

Select the table start

Select the table end

Select the previous page in the table

Select the next page in the table

Select the functions for preset entry

Display the "Basic Transformation/Axis Offset"

selection

Activate the datum of the selected line of the

preset table

Add the entered number of lines to the end of the

table (2nd soft-key row)

Copy the highlighted field (2nd soft-key row)

Insert the copied field (2nd soft-key row)

Reset the selected line: The TNC enters - in all

columns (2nd soft-key row)

Insert a single line at the end of the table (2nd

soft-key row)

Delete a single line at the end of the table (2nd

soft-key row)