Selecting the correct operating mode, Selecting the tool table for the test run – HEIDENHAIN TNC 620 (81760x-01) User Manual
Page 58

First Steps with the TNC 620
1.4
Graphically testing the first part (Advanced Graphic Features
software option)
1
58
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
1.4
Graphically testing the first part
(Advanced Graphic Features software
option)
Selecting the correct operating mode
You can test programs only in the Test Run mode:
Press the operating-mode key: The TNC goes into
the
Test Run operating mode
Further information on this topic
Operating modes of the TNC: See "Modes of Operation",
page 71
Testing programs: See "Test Run", page 513
Selecting the tool table for the test run
You only need to execute this step if you have not activated a tool
table in the Test Run mode.
Press the
PGM MGT key: The TNC opens the file
management
Press the
select type soft key: The TNC shows a
soft-key menu for selection of the file type to be
displayed
Press the
DEFAULT soft key: The TNC shows all
saved files in the right window
Move the highlight to the left onto the directories
Move the highlight to the
TNC:\ directory
Move the highlight to the right onto the files
Move the highlight to the file TOOL.T (active tool
table) and load with the ENT key: TOOL.T receives
the status
S and is therefore active for the test run
Press the
END key: Exit the file management
Further information on this topic
Tool management: See "Enter tool data into the table",
page 162
Testing programs: See "Test Run", page 513