beautypg.com

Tnc model, software and features – HEIDENHAIN TNC 620 (81760x-01) User Manual

Page 13

background image

TNC model, software and features

TNC 620 | User's Manual

HEIDENHAIN Conversational Programming | 3/2014

13

New Functions 73498x-02

The maximum number of characters for the NAME and DOC fields

in the tool table has been increased from 16 to 32 ("Enter tool data

into the table", page 162).
The columns ACC were added to the tool table ("Enter tool data

into the table", page 162).
Operation and position behavior of the manual probing cycles has

been improved ("Using 3-D touch probes (Touch Probe Function

software option)", page 464).
Predefined values can now be entered into a cycle parameter

with the PREDEF function in cycles (see User’s Manual for Cycle

Programming).
A new optimization algorithm is now used with the KinematicsOpt

cycles (see User’s Manual for Cycle Programming).
With Cycle 257, circular stud milling, a parameter is now available

with which you can determine the approach position on the stud

(see User's Manual for Cycle Programming)
With Cycle 256, rectangular stud, a parameter is now available with

which you can determine the approach position on the stud (see

User's Manual for Cycle Programming).
With the "Basic Rotation" probing cycle, workpiece misalignment

can now be compensated for via a table rotation ("Compensation of

workpiece misalignment by rotating the table", page 477)