5 using the 3-d touch probe, Overview, Selecting probe cycles – HEIDENHAIN iTNC 530 (340 49x-06) ISO programming User Manual
Page 473
HEIDENHAIN iTNC 530
473
14.5 Using the 3-D T
o
uc
h Pr
obe
14.5 Using the 3-D Touch Probe
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Selecting probe cycles
U
To select the Manual Operation or El. Handwheel mode of operation
U
Select the touch probe functions by pressing the
TOUCH PROBE soft key. The TNC displays additional
soft keys: see table above.
U
To select the probe cycle, press the appropriate soft
key, for example PROBING ROT, and the TNC
displays the associated menu.
Function
Soft key
Page
Calibrating the effective length
Calibrating the effective radius
Measuring a basic rotation using a line
Setting the datum in any axis
Setting a corner as datum
Setting a circle center as datum
Setting a center line as datum
Measuring a basic rotation using two
holes/cylindrical studs
Setting the datum using four
holes/cylindrical studs
Setting a circle center using three
holes/cylindrical studs