HEIDENHAIN iTNC 530 (340 49x-06) ISO programming - Manual (Page 24)

Chang
e
d functions with 340 49x
-03
24
Changed functions with 340 49x-03
„ In Cycle 22 you can now define a tool name also for the coarse
roughing tool (see User's Manual Cycles).
„ In the PLANE function, an FMAX can now be programmed for the
automatic rotary positioning (see “Automatic positioning:
MOVE/TURN/STAY
(entry is mandatory)” on page 408).
„ When running programs in which non-controlled axes are
programmed, the TNC now interrupts the program run and displays
a menu for returning to the programmed position (see
“Programming of noncontrolled axes (counter axes)” on page 530).
„ The tool usage file now also includes the total machining time,
which serves as the basis for the progress display in percent in the
Program Run, Full Sequence mode.
„ The TNC now also takes the dwell time into account when
calculating the machining time in the Test Run mode (see
“Measuring the machining time” on page 519).
„ Arcs that are not programmed in the active working plane can now
also be run as spatial arcs (see “Circular path C around circle center
CC” on page 209).
„ The EDIT OFF/ON soft key on the pocket table can be deactivated
by the machine tool builder (see “Pocket table for tool changer” on
page 176).
„ The additional status display has been revised. The following
improvements have been introduced (see “Additional status
displays” on page 85):
„ A new overview page with the most important status displays
was introduced.
„ The individual status pages are now displayed as tabs (as in
smarT.NC). The individual tabs can be selected with the Page soft
keys or with the mouse.
„ The current run time of the program is shown in percent by a
progress bar.
„ The tolerance values set in Cycle 32 are displayed.
„ Active global program settings are displayed, provided that this
software option was enabled.
„ The status of the Adaptive Feed Control (AFC) is displayed,
provided that this software option was enabled.