14 manual operation and setup, Programming: pallet editor – HEIDENHAIN iTNC 530 (340 49x-06) ISO programming User Manual
Page 46
46
14.1 Switch-On, Switch-Off ..... 446
14.2 Moving the Machine Axes ..... 450
Moving the axis using the machine axis direction buttons ..... 450
Incremental jog positioning ..... 451
Traversing with electronic handwheels ..... 452
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 462
Changing the spindle speed and feed rate ..... 463
14.4 Datum Setting without a 3-D Touch Probe ..... 464
Workpiece presetting with axis keys ..... 465
Datum management with the preset table ..... 466
14.5 Using the 3-D Touch Probe ..... 473
Selecting probe cycles ..... 473
Recording measured values from the touch-probe cycles ..... 474
Writing the measured values from touch probe cycles in datum tables ..... 475
Writing the measured values from touch probe cycles in the preset table ..... 476
Storing measured values in the pallet preset table ..... 477
14.6 Calibrating a 3-D Touch Probe ..... 478
Calibrating the effective length ..... 478
Calibrating the effective radius and compensating center misalignment ..... 479
Displaying calibration values ..... 480
Managing more than one block of calibrating data ..... 480
14.7 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 481
Basic rotation using 2 points: ..... 483
Determining basic rotation using 2 holes/studs: ..... 485