Ericsson G36 - Manual (Page 19)

Fixed Wireless Terminal: G32 & G36 19
• The trunk card must support either Busy Tone Detection (BTD) or
Polarity Reversal Detection on answer and release.
• The PBX can be programmed to utilize Least Cost Routing (LCR), if
available, to automatically choose the trunk where the G36 FWT is
connected.
• If the PBX does not offer LCR, choose the trunk where the G36
FWT is connected manually with a special dialed prefix. Check the
installation in the same way as before.
The G36 FWT is compatible with most analog PBXs on the market.
G36 FWT connectivity to the analog trunk of the PBX
If the PBX fulfils the requirements for FWT connectivity, listed above,
follow all the installation steps as described in the topic
Installing the
FWT on the Wall documented on page 13.
Note: A minimum distance of 3 meters between the G36 FWT
and the PBX is recommended. The cable distance between the
PBX and the G36 FWT should not exceed 600 meters, and the
connection cable should be at least 0.4mm
2 in diameter.
Warning: If you install more than one G36 FWT to a PBX, their
antennas have to be separated by 20 cm in height or 2 meters in
the horizontal.
If you are using an analog PBX – disconnect the telephone you have
used to enter the PIN and test the FWT, and connect the analog trunk
cable from the PBX to the FWT telephone line interface.
Check your PBX programming guide to see how to program your PBX
to route certain calls through the FWT trunk if you are using a Least Cost