Ericsson G36 - Manual (Page 13)

Fixed Wireless Terminal: G32 & G36 13
Now you have prepared the FWT for wall installation. Please, follow the
instructions below for complete wall installation.
Installing the FWT on the Wall
FWT Location
The GSM signal strength available at the FWT location affects the per-
formance of the unit. The stronger the GSM signal, the better the FWT
performance.
Tip: Test several potential locations by moving the FWT while
looking at the Radio LED. Select the location where the Radio
LED is continuous steady, or the location with the highest amount
of flashes.
Note: Moving the FWT as little as 20 cm can affect the GSM
reception quality.
Please consider the following recommendations:
• Always select an indoor indoor indoor indoor location, preferably close to a window and
as high as possible in the building. Generally, you will experience
better GSM signal strength in these places.
• Do not install the FWT in a wet or damp location.
• Do not install the FWT in an outdoor location.
• Do not install the FWT on walls or in rooms that contain large
amounts of metal, steel or wiring.
• Do not expose the FWT to extreme temperatures (near radiators,
cooling vents, etc).
If you experience poor reception quality, an outdoor antenna may im-
prove reception. Please refer to the topic
Accessories documented on
page 68 for more detailed information,
Number of Radio LED flashes Number of Radio LED flashes Number of Radio LED flashes Number of Radio LED flashes Location status Location status Location status Location status
0 OFF Unacceptable
1 - - - Acceptable
2 - - - - - - Good
3 - - - - - - - - - Very Good
Continuously ………………… Excellent
Location Testing Location Testing Location Testing Location Testing