HEIDENHAIN ND 730 v.3 - Manual (Page 37)

38
Multipoint Axis Error Compensation
Selecting the compensation table, entering an axis
correction
DATUM X
Enter the active datum for the error on
the axis to be corrected e.g. 27 mm, and
confirm with ENT.
2 7
SPACING X
Enter the spacing of the compensation
points on the axis to be corrected, e.g.
2
10 µm (equals 1.024 mm), and confirm
with ENT.
1 0
27.000
Compensation point no. 1 is displayed,
enter the associated compensation
value, e.g. 0.01 mm, and confirm with
ENT.
0
0 1
28.024
Enter all further compensation points. If
you press the MINUS key, the number
of the current compensation point is
shown in the X display.
Conclude entry.
Select the special functions.
PARAMETER
Select the dialog for entering the code
number.
CODE
Enter 105296 and confirm with ENT.
1 0 5 2
9 6
ENT
X
AXIS X
Select the axis to be corrected, e.g. X,
confirm with ENT.
X = FCT. X
Enter the axis causing the error, e.g. X
(screw pitch error), confirm with ENT.
•
•
X
SPEC
FCT
ENT
ENT
ENT
ENT
ENT
ENT
SPEC
FCT
Select the parameter function, if required,
by repeatedly pressing the TOOL key.
ENT
ENT
SPEC
FCT
or
or
730_770t4.pm6 21.07.2004, 08:38 38