HEIDENHAIN ND 730 v.3 - Manual (Page 29)

30
Operating Parameters
Operating parameters allow you to modify the operating
characteristics of your display unit and define the evaluation
of the encoder signals. Operating parameters that can be
changed by the user are called user parameters, and can be
accessed with the SPEC FCT key and the dialog PARAMETER
(user parameters are identified as such in the parameter list).
The full range of parameters can only be accessed via the
dialog "CODE" and input of the code number 95148.
Operating parameters are designated by the letter P and a
number. Example: P11. The parameter designation is shown
in the X display when a parameter is selected with the TOOL
and ENT keys.
The parameter setting is shown in the Z = ND 730/
Zo = ND 770 display.
Some operating parameters have separate values for each
axis. Such parameters have an additional index number from
1 to 3 with the ND 770 and from 1 to 2 with the ND 730.
Example:
P12.1 scaling factor, X axis
P12.2 scaling factor Zo axis (only ND 770)
P12.3 scaling factor, Z axis
The operating parameters are preset before the unit leaves
the factory. These factory settings are indicated in the
parameter list in boldface type.
Operating Parameters
Entering and changing operating parameters
To access the operating parameters
➤ Press the SPEC FCT key.
➤ Press SPEC FCT or TOOL until "PARAMETER" appears in
the X display.
➤ Confirm with ENT.
To select protected operating parameters
➤ Press the TOOL key to select the P00 CODE
user parameter.
➤ Enter the code number 95148.
➤ Confirm with the ENT key.
To page through the operating parameters
➤ Page forwards by pressing the ENT key.
➤ Page backwards by pressing the TOOL key.
To change parameter settings
➤ Press the minus key or enter the value and confirm
with the ENT key.
To correct an entry
➤ Press the CL key: the old value reappears in the input
line and becomes effective again.
To exit the operating parameters
➤ Press the SPEC FCT or CL key.
730_770t4.pm6 21.07.2004, 08:38 30