HEIDENHAIN ND 730 v.3 - Manual (Page 2)

HEIDENHAIN
Position display
(ND 730 only two axes)
∆
= Distance-to-go
R = Radius/diameter
display
Numerical input
• Change algebraic sign
• Call last dialog
• Change parameters
in the parameter list
Select radius/diameter display
in X axis
• Select special functions
• Page forward in the list of
special functions
• Cancel entry
• Reset operating mode
• Zero the selected axis
(if activated via P 80)
• Select parameter:
CL plus two-digit number
Status display:
SCL = Scaling factor
SET = Set datum
REF = Blinking:
Traverse the
reference points
On continuously:
Reference points have
been traversed
Inch= Inch display
• Confirm entry
• Page forward
in the parameter list
T = Selected tool
• Tool compensation
• Page backward in the list of
special functions
• Page backward in the list of
parameters
• Select coordinate axes
(ND 730 only X and Z)
• Select axis-specific operating parameters
730_770t1.pm6 21.07.2004, 08:35 2