HEIDENHAIN ND 730 v.3 - Manual (Page 14)

14
SPEC
FCT
Z 0
ENT
ENT 3
•
•
•
Entering tool data (relative datums)
Select tool, T starts blinking.
Enter tool number, e.g. 3,
and confirm with ENT.
Touch the workpiece end face with the
tool.
Select the special functions.
Select the "tool setting" function.
The decimal point next to "T" and
the decimal points below "T" start
blinking.
TOOL SET
Select the axis (e.g. Z), enter the position
of the tool tip (e.g. 0 mm), and confirm
with ENT.
SPEC
FCT
Touch the workpiece or turn the first
diameter.
Select the axis (e.g. X), enter the position
of the tool tip (e.g. 20 mm), and confirm
with ENT.
To set additional tools, change the tool,
select a new tool number and enter the
data for the next tool.
Exit the special functions.
X 2 0 ENT
When you work with the sum display, also set the
tool data when the sum display is active (ND 770
only)!
Datum Setting
SPEC
FCT
ENT
or
730_770t2.pm6 21.07.2004, 08:36 14