beautypg.com

Operating parameters – HEIDENHAIN ND 730 v.3 User Manual

Page 30

background image

31

List of operating parameters

P00 CODE Enter the code number

9 51 48:

Change protected operating parameters

66 55 44:

Display the software version (in the X axis)
Display the date of release (in the Y axis)

10 52 96:

Multipoint axis error compensation

P01 Unit of measurement

1)

Display in millimeters

MM

Display in inches

INCH

P03.1 to P03.3 Radius/diameter display

1)

Display position value as radius

RADIUS

Display position value as diameter

DIAMETER

P06 Select the sum display

Sum display default setting

SUM ON

Sum display selectable
with the Z0 and Z keys

SUM OFF

P11 Activate scaling factor

1)

Scaling factor active

SCALING ON

Not active

SCALING OFF

P12.1 to P12.3 Enter scaling factor

1)

Enter a scaling factor separately for each axis:
Entry value > 1: workpiece will “grow”
Entry value = 1: workpiece will remain the same size
Entry value < 1: workpiece will “shrink”
Input range:

0.111111 to 9.999999

Default setting:

1

Operating Parameters

P30.1 to P30.3

Counting direction

Positive counting direction with
positive direction of traverse

DIRECT. POS

Negative counting direction with
positive direction of traverse

DIRECT. NEG

P31.1 to P31.3 Signal period of the encoder

Input range:

0.00000001 to 99999.9999 µm

Default setting:

20 µm

P33.1 to P33.3 Counting step

0 - 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9
0 - 2 - 4 - 6 - 8
0 - 5

P38.1 to P38.3 Decimal places

1 / 2 / 3 / 4 / 5 / 6 (up to 8 with inch display)

P40.1 to 40.3 Define axis error compensation

No axis error compensation

COMP. OFF

Linear error compensation active

COMP. LIN

Multipoint error compensation active

COMP. MULTI

(See "Multipoint Axis Error Compensation")

1)

User parameter

730_770t4.pm6

21.07.2004, 08:38

31

This manual is related to the following products: