HEIDENHAIN ND 730 v.1 - Manual (Page 36)

37
Multipoint Axis Error Compensation
To select comp. value table and enter an axis correction
DATUM X
Enter the active datum for the error on
the axis to be corrected e.g. 27 mm, and
confirm.
2 7
SPACING X
Enter the spacing of the compensation
points on the axis to be corrected, e.g.
2
10 µ
m (equals 1.024 mm), and confirm.
1 0
2 7 . 0 0 0
Select compensation point no. 1, enter
the associated compensation value
e.g. 0.01 mm, and confirm.
0
0 1
2 8 . 0 2 4
Enter all further compensation points. If
you press the MINUS key, the number
of the current compensation point is
shown in the X display.
Conclude entry.
Select Special Functions
PARAMETER
Select dialog for entering the code
number.
C O D E
Enter 105296 and confirm with ENT.
1 0 5 2
9 6
ENT
X
AXIS X
Select the axis to be corrected, e.g. X,
confirm with ENT.
X = FCT. X
Enter the axis causing the error, e.g. X
(screw pitch error), confirm with ENT.
•
•
X
SPEC
FCT
ENT
ENT
ENT
ENT
ENT
ENT
SPEC
FCT
Select the Parameter function if required,
by repeatedly pressing the TOOL key.
ENT
ENT
SPEC
FCT
or
or