HEIDENHAIN ND 730 v.1 - Manual (Page 3)

Part I Operating Instructions
Fundamentals 4
Switch-On, Reference-Mark Traverse 10
Selecting Radius or Diameter Display 11
Separate Value/Sum Display
(only ND 770)
12
Datum Setting 13
Setting the absolute workpiece datum 13
Entering tool data (relative datums) 14
Holding Positions 15
Moving the Axes with Distance-To-Go 17
Taper Calculator 19
Error Messages 23
Part II
Installation and Specifications
25
Part I Operating Instructions
3
This manual is for ND display units with the following
software numbers or higher:
ND 730 for two axes AA00
ND 770 for three axes AA00
About this manual!
This manual is divided into two parts:
Part I: Operating Instructions:
• Fundamentals of positioning
• ND functions
Part II: Installation and Specifications:
• Mounting the display unit on the machine
• Description of operating parameters