HEIDENHAIN ND 730 v.1 - Manual (Page 30)

31
List of operating parameters
P1 Unit of measurement 1)
Display in millimeters MM
Display in inches INCH
P3.1 to P3.3 Radius/diameter display 1)
Display position value as radius RADIUS
Display position value as diameter DIAMETER
P11 Activate scaling factor 1)
Scaling factor active SCALING ON
Not active SCALING OFF
P12.1 to P12.3 Enter scaling factor 1)
Enter a scaling factor separately for each axis:
Entry value > 1: workpiece will “grow”
Entry value = 1: workpiece will remain the same size
Entry value < 1: workpiece will “shrink”
Input range:
0.111111 to 9.999999
Factory setting: 1
P30.1 to P30.3 Counting direction
Positive counting direction with
positive direction of traverse
DIRECT. POS
Negative counting direction with
positive direction of traverse
DIRECT. NEG
Operating Parameters
P32.1 to P32.3 Subdivision of the encoder signals
1024 / 1000 / 800 / 512 / 500 / 400 / 256 / 200
128 / 100 / 80 / 64 / 50 / 40 / 20 / 10 / 8 / 5 / 4 / 2 / 1 / 0.8 /
0.5 / 0.4 / 0.2 / 0.1
P33.1 to P33.3 Counting step
0 - 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9
0 - 2 - 4 - 6 - 8
0 - 5
P38.1 to P38.3 Decimal places
1 / 2 / 3 / 4 / 5 / 6 (up to 8 with inches display)
P40.1 to 40.3 Define axis error compensation
Axis error compensation not active CORR. OFF
Linear axis error compensation active CORR. LIN
Multipoint axis error compensation active CORR. ABS
(See "Multipoint Axis Error Compensation")
1) User parameter