HEIDENHAIN ND 730 v.1 - Manual (Page 14)

14
SPEC
FCT
Z 0
ENT
ENT
3
•
•
•
Entering tool data (relative datums)
Select tool, T begins to blink.
Enter tool number, e.g. 3,
and confirm with ENT.
Touch the workpiece with the tool.
Select Special Functions.
Select the Tool Set function.
The decimal point beside "T" and
the decimal points beneath it begin
to blink.
TOOL SET
Select the axis (for example Z), enter the
position of the tool tip (for example
0 mm), and confirm with ENT.
SPEC
FCT
Touch the workpiece or turn the first
diameter.
Select the axis (for example X), enter the
position of the tool tip (for example
20 mm), and confirm with ENT.
To set additional tools, change the tool,
select a new tool number and enter the
data for the next tool.
End the function.
X 2 0
ENT
When you work with the sum display, also set the
tool data when the sum display is active (ND 770
only)!
Datum Setting
SPEC
FCT
ENT
or