Polaris 2013 BRUTUS Owner's Manual - Manual (Page 72)

71
ATTACHMENT ARM
Removing And Installing (Models HD and
HD
PTO )
The PRO-TACH attachment system is used for fast changing
of buckets and other attachments. See the appropriate
attachment Owner’s Manual to install other attachments.
Removing (Cont’d):
Tip: The utility vehicle is
shown equipped with the
optional cylinder Stow Kit
(Item 1). See your Polaris
dealer for parts.
Rotate the tilt cylinder up
and into the storage posi-
tion. Install the cylinder
into the Stow Kit (Item 1)
(if equipped). If not
equipped with the Stow Kit cylinder retainer, a heavy tie strap
can be used to secure the cylinder to the grille in the storage
position.
Position the cylinder to the
frame and install the pin
(Item 3) and the retainer
pin (Item 3) to secure the
lift cylinder in the storage
position.
Tip: When the pins (Item 5)
are removed from the
attachment arm, it will be
free to tilt down to the
ground. Support the
attachment arm while the
pins are being removed.
Remove the two retainer
pins (Item 4) and pins
(Item 5) and lower the
attachment arm fully.
Reinstall the pins (Item 5)
and the retainer pins (Item
4) into the attachment arm
for storage.
1
2
3
5
4
4
5
4
4