Polaris 2013 BRUTUS Owner's Manual - Manual (Page 26)

25
FEATURES AND CONTROLS
Seat Removal
Pull up on the rear of the seat and tilt it
toward the front of the vehicle. Install
the seat by sliding the tabs into the
front of the seat base. Push down
firmly on the rear of the seat until the
pins are fully seated into the grommets.
Tip: For Model HD PTO ; a seat switch is
located under the operator’s seat. Set
the seat aside if possible to avoid dis-
connecting the seat switch. If the seat
switch is disconnected, the harness
must be secured in it’s original position
to avoid harness damage.
Seat Belts
This POLARIS vehicle is
equipped with three-point
lap and diagonal seat belts
on all external seats.The
center seat is equipped
with a lap-style seat belt.
Always make sure the seat
belts are secured for all
riders before operating.
WARNING! Falling from a
moving vehicle could result in
serious injury or death.
Always fasten your seat belt
securely before operating or
riding in the BRUTUS.
To wear the seat belt properly, follow this procedure:
1. For 3-point belts, pull the seat belt latch downward and
across your chest toward the buckle at the inner edge of
the seat. The belt should fit snugly across your hips and
diagonally across your chest. Make sure the belt is not
twisted. For lap style belts, place the belt across your lap
as low on your hips as possible. Make sure that the belt is
not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.
Tip: The center belt must be tightened manually by pulling on the
strap.
4. To release the seat belt, press the square red button in the
buckle's center.
Seat
Switch Harness
Model HD PTO Only
Buckle
Latch Plate