Polaris 2013 BRUTUS Owner's Manual - Manual (Page 69)

68
OPERATION
Operating The PTO (HD
PTO
)
The BRUTUS HD PTO utility vehicle is factory equipped with
a PTO.
The PTO has a rated speed of 2000 RPM.
Read and understand the attachment Owner’s Manual and the
utility vehicle Owner’s Manual prior to installing or using any
attachment.
WARNING!
Avoid Injury Or Death
• Steering and braking can be affected by the attachment, four wheel
drive and the rear differential lock. Do not exceed the rated lift
capacities.
• Always carry loads low. Slow down when turning.
Always inspect the utility vehicle and the attachment before
use. Inspect for damaged or loose parts, damaged or missing
PTO shields and guards.
New operators must operate the utility vehicle in an open area
without bystanders. Operate the controls until the utility vehi-
cle can be handled at a efficient and safe speed for all condi-
tions of the work area.
Check for safe operating speed, safe stopping distances and
braking characteristics that may be different with each type of
attachment. Know that when attachments are installed, the
utility vehicle braking distance increases.
Before beginning operation, inspect the work area for unsafe
conditions.
Look for drop-offs or rough terrain. Have underground utility
lines (gas, water, sewer, irrigation, etc.) located and marked.
Remove objects or other construction material that could dam-
age the utility vehicle or cause personal injury.
Do not engage the PTO system at higher engine rpm with
attachment under load. Always engage the PTO system at a
lower engine rpm and with attachment under a no load condi-
tion.
WARNING!
Avoid Injury Or Death
• Do NOT exceed the rated attachment PTO speed.
• Stay clear of rotating driveline.
• Keep bystanders away.
• Keep hands, feet, clothing and long hair away.
• Keep PTO shields and all guards in place.
• Disengage PTO, put transmission in Park, stop the engine and
make sure all rotating components are stopped before exiting utility
vehicle.
• Do NOT service the utility vehicle or implement with the PTO
engaged.
• Do NOT service the implement in a raised position unless properly
blocked and with all rotating components stopped.
• Disengage PTO for road travel.