Polaris 2016 RZR 900 - Manual (Page 29)

27
FEATURES AND CONTROLS
Switches
Headlight Switch
Use the headlight switch to turn the lights on
and off and to change the lights from high beam
to low beam. The ignition switch must be in the
ON position to operate the headlights.
Press the top of the rocker switch toward the
dash to place the headlights on high beam.
Move the rocker switch to the center position to
place the headlights on low beam. Press the
bottom of the rocker switch to turn off the
headlights.
If the headlight switch is ON when the ignition switch is turned off, the
lights will remain on for approximately 30 seconds.
All Wheel Drive (AWD) Switch
The AWD Switch has either
two or three positions,
depending on your model’s
features:
• All Wheel Drive (AWD)
• Two Wheel Drive (2WD)
• Turf Mode/Differential
Unlocked (1WD)
See page 38 for AWD
operating instructions.
Electronic Power Steering (EPS)
Electronic power steering (if equipped) engages when the ignition key is
turned to the ON position. EPS remains engaged whether the vehicle is
moving or idle.
The EPS warning indicator briefly illuminates when the key is turned to
the ON position. See page 41.
To conserve battery power, the EPS will shut down 5 minutes after the
engine is stopped if the key remains in the ON position. The EPS
warning indicator will illuminate to indicate the EPS has shut down.
If the light remains on after starting the engine, the EPS system is
inoperative. Your POLARIS dealer can assist.
HIGH
LOW
AWD
2WD
AWD
2WD
1WD