Maintenance, Lights, Headlight beam adjustment – Polaris 2016 RZR 900 User Manual
Page 122
120
MAINTENANCE
Lights
Headlight Beam Adjustment
The headlight beam can be adjusted slightly upward or downward and
to the left or right.
1. Position the vehicle on a level surface. The headlight should be
approximately 25 ft. (7.6 m) from a wall.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
4. Apply the brakes. Start
the engine. Turn the
headlights to high beam.
5. Include the weight of a
rider on the seat while
performing this step.
Observe the headlight
aim. As a starting point,
the most intense part of
the headlight beam
should be 2 inches (5 cm)
below the mark on the
wall. Adjust to operator
preference.
6. Tighten or loosen the three (3) headlight screws on the rear of the
headlight to adjust the beam upward or downward or to the left or
right.
25 ft.
(7.6 m)
X
X
2 in. (5 cm)
Adjustment
Screws
- 2016 RZR 900 EPS Trail 2016 RZR 900 XC Edition 2016 RZR S 900 2016 RZR S 900 EPS 2016 RZR 4 900 EPS 2016 RZR S 1000 EPS 2014 RZR 900 2014 RZR 4 900 2015 RZR XP 1000 2015 RZR XP 4 1000 2015 RZR 900 2015 RZR 900 EPS Trail 2015 RZR 900 XC Edition 2015 RZR S 900 2015 RZR S 900 EPS 2015 RZR 4 900 EPS 2016 RZR XP Turbo 2015 RZR XP 1000 EPS High Lifter Edition 2016 RZR XP 1000 EPS High Lifter Edition 2014 RZR 800 2014 RZR S 800 2014 RZR 4 800 2016 RZR 570 2016 RZR 570 EPS 2013 RZR 570 2011 RZR 2011 RZR S 2011 RZR 4 2009 Ranger RZR S 2010 RZR 2010 RZR EPS 2009 Ranger RZR 170 2012 ATV RZR 170 2016 ATV RZR 170 2013 RZR 170 2010 RZR 170 2011 RZR 170 2014 RZR 170 2010 RZR 4 2015 RZR 170 2012 RZR 2012 RZR S 2012 RZR 4 2013 RZR 2013 RZR S 2013 RZR 4 2011 Ranger RZR XP 900 2012 RZR XP 900 2013 RZR XP 900 2013 RZR XP 4 900 2012 RZR 570 2014 RZR XP 1000 2014 RZR XP 4 1000 2016 RZR XP 1000 2016 RZR XP 4 1000 2014 RZR 570 2015 RZR 570 2015 RZR 570 EPS