Polaris 2016 RZR 900 - Manual (Page 116)

114
MAINTENANCE
Suspension Settings (RZR S/RZR XC/RZR 4)
Front/Rear Spring Preload
The factory setting is appropriate for nearly
all riding conditions. Since the vehicle is
equipped with full skid plates, adjustment is
not necessary.
If desired, the suspension may be adjusted to
maintain vehicle clearance height when
carrying loads. Please see your POLARIS
dealer for the tool required to make
suspension adjustments. Elevate the vehicle
slightly for easier adjustment.
Follow these guidelines if you make adjustments to this suspension.
• Always return the suspension to the factory setting after the load is removed
from the vehicle. The increased suspension height will negatively impact
vehicle stability when operating without a load.
• Always apply the same adjustment setting to all four wheels.
• Do not increase the spring preload by more than one inch (25.4 mm) over the
factory setting.
Factory Preload Settings
Location RZR S RZR XC Edition RZR 4
Front 7 7/8”
(200 mm)
4 7/8”
(123.2 mm)
6 1/2”
(165.1 mm)
Rear 3 5/16”
(84 mm)
1 3/16”
(30 mm)
1 9/16”
(39.7 mm)
Preload Setting
Measurement