beautypg.com

Maintenance and lubrication, Storage – Polaris Series 11 Polaris Ranger 4x4 User Manual

Page 93

background image

91

MAINTENANCE AND LUBRICATION

Cleaning Your RANGER

Keeping your vehicle clean will not only improve its appearance but it

can also extend the life of various components. With a few

precautions, your vehicle can be cleaned much like an automobile.
The best and safest way to clean your vehicle is with a garden hose and

a pail of mild soap and water. Use a professional type washing mitten,

cleaning the upper body first and the lower parts last. Rinse with water

frequently and dry with a chamois to prevent water spots. NOTE: If

warning labels are damaged, contact your Polaris dealer for free

replacement.
If a high pressure type car wash system is used, extreme care must be

taken to avoid water damage to the wheel bearings, transmission seals,

body panels, brakes, headlights and warning labels. Many expensive

repair bills can result from using high pressure detergent systems.
NOTE: If a high pressure car wash is used, grease all zerk fittings

immediately after washing. Also run the vehicle to evaporate any

water that may have entered the engine or exhaust system.

Storage

If your vehicle is to be placed in extended or off season storage, the

following steps should be taken to preserve its condition.
1. Perform all necessary repairs and thoroughly clean the vehicle.
2. Remove the spark plug and pour approximately one ounce of

Premium 4 oil into the cylinder. Operate the starter for a few

seconds and reinstall the spark plug.

3. Remove the battery. Store it in a cool, dry place out of the sun.
4. Lubricate suspension pivot points, lower steering post and rear axle

fittings.

5. Drain the engine side cover (RANGER 2x4, 4x4, 6x6).
6. Block the vehicle so all tires are suspended off the ground.
7. Spray oil on all unpainted metal surfaces to prevent rusting. Avoid

getting oil on rubber parts or in the brakes.

8. Lubricate all cables.
9. Tie a plastic bag over the exhaust pipe and air cleaner inlet to

prevent moisture or small animals from entering.

10. Cover the vehicle with a canvas cover. Do not use plastic or coated

materials since they do not allow ventilation for the vehicle.