Polaris Series 11 Polaris Ranger 4x4 - Manual (Page 59)

57
MAINTENANCE AND LUBRICATION
Periodic Maintenance Schedule
Item Frequency Remarks
Coolant strength/
pressure test system
(if equipped)
100 hrs Inspect strength seasonally;
pressure test system annually
Engine Mounts 100 hrs Inspect
J
L
Valve Clearance 100 hrs Inspect; adjust
L
Spark Plug 100 hrs Inspect; replace if necessary
J
L
Ignition Timing 100 hrs Inspect and adjust as needed
J
Front Hub Bearings 100 hrs Check at 100 hours and replace as
required
J
L
Fuel System 100 hrs Check for leaks at fuel cap, lines,
fuel filter, pump and carburetor. Re-
place lines every two years.
Fuel Filter 100 hrs Replace annually
Cooling System
hoses
100 hrs Inspect
"
Front Gearcase Oil 100 hrs Check monthly; change annually
J
Clutches (drive and
driven)
100 hrs Inspect, clean
J
Brake fluid 200 hrs Change every two years
J
Front wheel bearings 300 hrs Inspect; replace if necessary
Spark arrestor 300 hrs Clean out
L
Idle Speed As required Adjust
Engine side cover As required Drain moisture after driving in water
J
Toe adjustment As required Periodic inspection, adjust when
parts are replaced
Headlight Aim As required Adjust if necessary
"
More often under severe use, such as dirty or wet conditions
L Emission Control System Service (California)
J
Dealer service item