Polaris Series 11 Polaris Ranger 4x4 - Manual (Page 70)

68
MAINTENANCE AND LUBRICATION
Gearcases
Middle Gearcase (RANGER 6x6)
The middle gearcase lubricant level should be checked at 25 hours or
monthly, whichever comes first. Middle gearcase oil should be
changed annually.
NOTE: Refer to the Gearcase Specifications Chart on page 69.
Always use Polaris Angle Drive Fluid. See page 100 for the part
numbers of Polaris products.
The middle gearcase fill plug (1) is located on the driver’s side of the
gearcase.
Oil Check
1. With the RANGER on a level
surface, remove the middle
gearcase fill plug and check the
lubricant level. Lubricant
should be even with the bottom
thread of the fill plug hole.
2. Reinstall the fill plug and
torque to specification.
Oil Change
1. Remove the fill plug.
2. Remove the drain plug (2) from
the bottom of the gearcase and drain the oil into a drain pan.
Discard used oil properly.
3. Clean and reinstall the drain plug. Torque to specification.
4. Add the recommended drive fluid until it reaches the bottom thread
of the fill plug hole.
5. Reinstall the fill plug and torque to specification. Check for leaks.
1
2