Operation, Starting the engine – Polaris 2010 Ranger XP User Manual
Page 48

44
OPERATION
Starting the Engine
1. Always start the engine outdoors or in a well-ventilated area.
2. Sit in the driver's seat and fasten the seat belt.
3. Apply the brakes. Engage the park brake.
4. Shift the transmission to neutral.
5. Do not press the throttle pedal while starting the engine. Turn the
ignition key past the ON/RUN position to START. Engage the
starter for a maximum of five seconds. Release the key when the
engine starts.
6. If the engine does not start within five seconds, release the ignition
switch and wait five seconds. Repeat steps 5 and 6 until the engine
starts.
7. Vary the engine RPM slightly with the throttle to aid in warm up
until the engine idles smoothly.
NOTICE: Operating the vehicle immediately after starting could cause engine
damage. Allow the engine to warm up for several minutes before
operating the vehicle.
- 2010 Ranger HD 2010 Ranger 6x6 2010 Ranger Crew 2010 Ranger 4x4 2010 Ranger EV 2011 Ranger EV 2011 Polaris EV 2011 Polaris LSV 2011 Ranger 4x4 500 EFI 2011 Ranger Crew 500 EFI 2011 Ranger 400 2010 Ranger 400 HO 2012 Ranger Diesel 2011 Ranger Diesel 2014 Ranger Diesel 2014 Ranger Crew Diesel 2011 Ranger XP 800 2011 Ranger 800 HD 2011 Ranger 800 6x6 2011 Ranger 800 Crew 2013 Ranger 500 Midsize 2013 Ranger Crew 500 2013 Ranger Diesel 2012 Ranger XP 800 2012 Ranger 800 HD 2012 Ranger 800 6x6 2012 Ranger 800 Crew 2013 Ranger 800 2013 Ranger 6x6 800 2013 Ranger Crew 800 2012 Polaris EV 2012 Polaris LSV