Polaris 2000 Universal Snowmobile - Manual (Page 80)

75
MAINTENANCE
Headlight Adjustment
The headlight can be adjusted for vertical
aim using the following procedure:
1. Place snowmobile on a level surface
with headlight approximately 25’
(7.6m) from a wall.
2. Measure distance from floor to
center of headlight and make a mark
on the wall.
3. Start engine and turn headlight
switch to high beam.
4. Observe headlight aim. The most
intense part of the headlight beam
should be aimed 2″ (5.1 cm) below
the mark placed on the wall in Step 2.
NOTE: Rider weight must be
included on the seat.
5. On evolved models, turn the
adjustment knob (B) located inside
the hood just below the headlamp
opening. Turn knob in or out as
needed for proper aim. On
aggressive models, insert a Phillips
screwdriver into the access hole (C)
on the top of the instrument housing
and turning the screw until correct
adjustment is achieved.
25’ (7.6 m)
Lamp Center
Height
2″ (5.1 cm)
C
B
OR