Polaris 2000 Universal Snowmobile User Manual

Page 43

OPERATION

Pre-Starting

WARNING

Before starting the engine, always refer to all safety warnings pertaining to snow-

mobile operation. Never start your snowmobile without checking all components

to be sure of proper operation. See Operation Warnings beginning on page 10.
Important safety items include, but are not limited to:

Throttle system

Brake system

Steering system

These systems must be checked each time before starting the engine. Incorrect

adjustments, damage, or excessive wear due to neglect could result in personal

injury and/or damage to the snowmobile.

Starting a Cold Engine (Manual Start)

1. Turn key to “On”.
2. Pull kill switch (shut-off switch) up to “run” position.
3. Flip choke toggle to “Full On” position.
4. Grasp starter handle and pull slowly until recoil engages; then pull to start.

CAUTION:

Do not pull the starter rope to its full extended position or allow it to snap back into

the housing as damage can result.
NOTE: Do not depress throttle until engine starts.

5. After engine starts, the choke toggle should be flipped to “Off” position. If the

engine slows or wants to stop, intermittent choking to the “Half On” position is

helpful.

Starting a Cold Engine (Electric Start)

1. Flip choke toggle to “Full On” position.
2. Pull kill switch (shut-off switch) up to “run” position.
3. Turn key to “Start” position and crank engine.
4. After engine starts, release key to “On” position and flip choke toggle to “Off”. If

the engine slows or wants to stop, intermittent choking to the “Half On” position

is helpful.

NOTE: Do not depress throttle until engine starts.