Grass Valley Zodiak Installation Planning Guide - Manual (Page 41)

Zodiak Installation Planning Guide 41
Specifications
Analog Reference Input
Signal Type Composite Color Black (NTSC or PAL), 525 (60 Hz) or 625 (50 Hz)
Connectors Two 75 ohm BNC
Return Loss > 40 dB to 5 MHz
Impedance 75 ohm loop through
System Timing
Switcher Output Delay (nominal) 49 microseconds
a Approximate value
Table 16. Zodiak Mechanical Specifications
Component Depth Width Height Weight a Rack Units
Standard
Video Processor Frame 22.13 in. / 562 mm b 19.0 in. /483 mm c 12.25 in. / 311 mm 79lb/36 kg 7
Main Panel 18.75 in. / 476 mm d, e 40.97 in. / 1041 mm 5.82 in. / 148 mm f 86 lb/39 kg N/A
Menu Panel g 4.30 in. / 109 mm 14.75 in. / 375 mm h 10.1 in. / 257 mm 17 lb/7.7 kg N/A
Options
KAL-24AUX1 Remote Aux Panel 2.0 in. / 51 mm 19.0 in. / 483 mm 1.75 in. / 45 mm 2.25 lb/1.02 kg 1
KAL-24AUX2 Remote Aux Panel 2.5 in. / 64 mm 19.0 in. / 483 mm 3.5 in. / 89 mm 4.5 lb /2.04 kg 2
KAL-24AUX3 Remote Aux Panel 2.5 in. / 64 mm 19.0 in. / 483 mm 5.25 in. / 133 mm 6.75 lb/3.06 kg 3
KAL-32AUX1 Remote Aux Panel 5.25 in. /133 mm 19.0 in. / 483 mm 1.75 in. / 44 mm 2.06 lb/0.93 kg 1
KAL-32AUX2 Remote Aux Panel 4.25 in. / 108 mm 19.0 in. / 483 mm 3.5 in. / 89 mm 2.25 lb/1.02 kg 2
a All weights approximate.
b Allow an extra 4.0 in. (102 mm) for cable.
c Allow an extra 4.0 in. (102 mm) on the left and right of the frame for air flow.
d Allow a minimum of 6.0 in. (152 mm) of clear space at the rear of the Main panel below the mounting surface for proper cable clearance
and air flow. Allow an extra 8.0 in. (203 mm) to 10.0 in (254 mm) of mounting surface behind the Main panel for peripheral components.
e Indicated measurement is for the lid. Refer to installation detail for tub measurements.
f Add 0,25 in. (6 mm) for rubber feet on bottom of tub if required. Indicated measurement is from bottom surface of tub to top surface
of lid.
g Not including mounting bracket.
h Allow an extra 5.8 in. (147 mm) clearance for the CD-ROM and fan exhaust.
Table 15. Zodiak System Specifications - (continued)