Grass Valley Zodiak Installation Planning Guide - Manual (Page 17)

Zodiak Installation Planning Guide 17
Installation
For installing the Menu panel into a console cutout, the mounting brackets
without the Flush Mount bezel can be used to support the top and bottom
of the Menu panel in the console cutout (
Figure 15 ). Slots in each mounting
bracket allow adjusting for variable height adjustment to match console
thickness. Eight wood screws (not provided) are required for securing the
mounting brackets to the console. Dimensions for the console cutout
(without the Flush Mount bezel) are given in
Figure 16 .
CAUTION Console thickness should not be less than 0.5 in./13 mm for proper support
of the Menu panel.
Figure 15. Menu Panel Console Installation
Figure 16. Menu Panel Console Cutout Dimensions
Left Side View
Brackets (x2) slotted for
variable height adjustment
Menu Panel Cabling
Including External
CD-ROM Drive
Panel Top Panel Bottom
8096_03_01_r2
Mounting Brackets
x4 x4
Console thickness:
1.25 in./32 mm (maximum)
0.5 in./13 mm (minimum)
10.31 in.
262 mm
If console thickness exceeds
1.25 in. / 32 mm, route these
areas from far side.
14.81 in. / 376 mm
4x R 0.0625 in. / 1.5 mm permitted
2x 0.85 in.
22 mm
8096_03_02r0