Grass Valley XSwitch Feb 01 2005 - Manual (Page 31)

30 ©2001 XSWITCH Installation and Operations Manual
$SSHQGL[ $ 5HPRWH $FWLYDWLRQ
Commands
Device ID: The following command is used to obtain the device ID type.
Command: 0 - Get Device ID Code
_____________________________________________________________________________________
Parameters Reply
None .......................... (Send copyright message) Copyright Message
_____________________________________________________________________________________
Definitions:
_____________________________________________________________________________________
Examples: Reply
0,1 XSWITCH Ver 1.0 Copyright 2001, ParkerVision
Get/Set Switch State: The following command is used to get or set the switch state
Command: 1 - Get/Set Switch State
_____________________________________________________________________________________
Parameters Reply
None .......................... (Send Switch State) [ A - E ]
[ A - E ]....................... (Set Switch State) [ A - E ]
_____________________________________________________________________________________
Definitions:
[ A - E ] - ASCII characters 'A' through 'E'
_____________________________________________________________________________________
Examples: Reply
Get current switch state
1 A
Set switch state to 'B'
1,B B
Set switch state to 'C'
1,C C
Screen Capture: The following command is used to capture data currently displayed on the LCD.
Command: 2 - Screen Capture
_____________________________________________________________________________________