Grass Valley PFR600/E - Manual (Page 49)

Replacing data ports
20 February 2004 PFR600/E Instruction Manual 49
Replacing data ports
The PFR600/E uses either 1Gb/s copper SFPs or 2GB/s optical SFPs as the Host Fibre
Channel data ports, and 2Gb/s SFPs as the Fibre Channel Loop data ports.
To replace the data ports:
1. Remove cabling and remove the data port as shown.
2. Insert the replacement data port into the module as shown, then reconnect cabling.
3. Verify the Fibre Channel connection using the port Loop LED. Refer to “Interpreting
rear panel status LEDs” on page 42 .
Optical SFP adapter
Tab
Remove
white cap
Remove
white cap