Installing the lbb or raid controller – Grass Valley PFR600/E User Manual
Page 48
Chapter 3 Servicing the PFR600 Series RAID
48
PFR 600/E Instruction Manual
20 February 2004
Installing the LBB or RAID Controller
To install the LBB or RAID Controller:
1. Insert the replacement module into the empty bay. Make sure the module is seated.
2. Push up the two ejector levers to seat the module.
3. Tighten the captive screws.
4. Reconnect cabling.
5. Verify module initialization using rear panel status LEDs. Refer to
6. Ensure that the replacement drive firmware matches that of the other controller. Refer
to Chapter 3, “Working with Storage Using GVG Disk Utility”, in the Profile XP
System Guide for information on checking and loading controller firmware.
7. If installing a RAID controller, configure the network and SNMP settings as
described in the PVS Installation Guide.
8. Check module status using NetCentral or GVG Disk Utility. If required, update the
firmware to match the version on the other RAID controller using GVG Disk Utility.
2921
1
2
3