Grass Valley PFR600/E - Manual (Page 43)

LBB 7-segment display codes
20 February 2004 PFR600/E Instruction Manual 43
LBB 7-segment display codes
The following table shows event codes for the rear panel 7-segment display on each
LBB.
Code Type Blink Rate Meaning
0 thru 9 Informational Steady or
alternating with
other code. Chassis address. Refer to “Chassis address setting
requirement” on page 28 .
A Warning Alternating with
chassis address Fibre Channel speed has changed. Power cycle of
all connected RAID chassis is required.
C Power-up Steady during
power-up
Initially displayed during cold boot, will switch to
chassis address within 30 seconds
C Critical Steady >30
seconds from
power-up If C remains longer than 30 seconds after power up,
the LBB has failed. Board may not be fully seated
or may have suffered a critical error during a
firmware upgrade.
F Critical Alternating with
chassis address An error or event has occurred that requires human
intervention. Check disk LEDs and rear panel
LEDs. Also, check system status using NetCentral.
. Informational Blinking
throughout
operation Indicates the LBB is functioning properly.
. Critical Blinking halted The LBB has critically failed (steady for greater
than 30 seconds)
H Informational Alternating with
the chassis
address A firmware update is in progress
H Warning Steady for short
duration with no
alternating Ethernet link has been detected
H Identify Alternating with
the chassis
address LBB has been sent an identify command by GVG
Disk Utility