Grass Valley RS-422 Interface Board - Manual (Page 37)

Copying the Driver Diskette Contents to the System Drive
RS-422 Interface Board Installation 37
Copying the Driver Diskette Contents to the System Drive
In this procedure you will copy the contents of the Windows NT driver diskette
onto the system drive. This will make it convenient if you need access to these files
in the future.
To copy the contents of the Windows NT Driver Diskette:
1. Create a new folder under c:\profile\drivers called comtrol .
NOTE: Some Profile systems already have the device driver software in the
“comtrol” directory. If the device driver software is already on the system
hard drive, you can skip the rest of this procedure.
2. Copy all the files from the driver diskette A:\winnt directory to the new
comtrol directory you just created.
3. Remove the Windows NT driver diskette.
This completes the RS-422 Interface board installation procedure.