Grass Valley RS-422 Interface Board - Manual (Page 28)

Installation Procedures
28 RS-422 Interface Board Installation
Replacing the RS-422 Board Interface Cable
The kit includes a new interface cable for the RS-422 Connector Panel.
To replace the RS-422 Board interface cable:
1. Reinstall the Profile system in the rack. If necessary, refer to the Profile
Installation Manual for rack mounting instructions.
2. Replace the cable connecting the RS-422 Connector Panel to the RS-422
Interface board with the cable supplied with this kit as shown in Figure 11.
Figure 11. Connecting the RS-422 Connector Panel interface cable
3. Reconnect all other external cables previously removed.
4. Connect power to the Profile system and proceed with “Installing the RS-422
Interface Board Device Driver” on page 29.
J1 J17 J13 J16 J15 J14 J6 J7 J4 J3 J2 J5 J12 J11 J9 J8 J10
9676-62
RS-422 Connector Panel
RS-422 Communications
(Ports 1-8)
Remote I/O
RS-422