Grass Valley RS-422 Interface Board - Manual (Page 24)

Installation Procedures
24 RS-422 Interface Board Installation
Reinstalling Board Hold-down Brackets
Now that the RS-422 Interface board is installed, you are ready to reinstall the
board hold-down brackets. This involves modifying the front hold-down bracket
by removing the bracket extender for slot J17, since it is no longer needed.
To reinstall the board hold-down brackets:
1. Use the Torx tool with the T15 bit to remove the extender retaining screw
from the front hold-down bracket as shown in Figure 8. Discard the extender
and screw.
Figure 8. Removing the board hold-down extender for slot J17
0519-4