Grass Valley RS-422 Interface Board - Manual (Page 15)

Removing the Chassis Covers
RS-422 Interface Board Installation 15
Removing the Chassis Covers
Use the following procedure to remove the chassis covers:
1. Confirm that the Profile system power is switched off and the power cord is
removed.
2. Use the Torx tool with the T10 tip to remove the top screws from the front
chassis cover ( Ê in Figure 1) and then use the T15 tip to remove the
pan-headed screws from the side of the chassis. The front chassis cover must
be removed first because it overlaps the rear chassis cover.
NOTE: Take care not to lose these chassis screws. They are required to meet
the EMI specifications for the Profile system.
Figure 1. Removing the front and rear chassis covers
3. Use the Torx tool with the T10 tip to remove the rear chassis cover
( Ë in Figure 1) which covers the circuit boards.
9675-9
2
1