Grass Valley RS-422 Interface Board - Manual (Page 16)

Installation Procedures
16 RS-422 Interface Board Installation
Removing the Circuit Board Hold-down Brackets
There are two hold-down brackets located in the circuit board area of the chassis
which must be removed in order to replace boards.
To remove the board hold-down brackets:
1. Use the Torx tool with the T10 tip to remove the exterior screw
(
Ê in Figure 2) that secures the rear board hold-down bracket.
2. Lift the bracket (
Ë in Figure 2) up and out of the chassis and set it aside.
3. Use the Torx tool with the T10 tip to remove the interior screw
(
Ì in Figure 2) that secures the front board hold-down bracket.
4. Lift the bracket (
Í in Figure 2) up and out of the chassis and set it aside.